Ladder Stabilizers for Little Giant | Level-EZE Compatible Auto Leveler

The Little Giant WingSpan is a wall standoff accessory that braces an extension ladder away from a wall surface, widening the contact points for improved lateral stability. It differs from the Level-EZE, which is a base-mounted automatic leveler that adjusts up to 9.5 inches for uneven ground. Together or separately, these accessories address different aspects of ladder safety.

Level-EZE uses precision steel gears connected by an aircraft-quality aluminum housing at the ladder base. When you set the ladder down, both legs automatically adjust in 3/16-inch increments and lock with as little as 9 lbs of weight applied — stabilizing the ladder on slopes, stairs, curbs, and uneven terrain in under one second, with no manual input required.

Level-EZE is compatible with aluminum and fiberglass straight, extension, combination, stepladder, and platform ladders, including Type 1AA ladders rated up to 375 lbs. It is available in specific models for each ladder type and material, and is offered factory-installed through Werner, Louisville, Bauer, Little Giant, and other major manufacturers.

No. Level-EZE does not affect the ladder manufacturer's warranty when properly installed — a fact acknowledged by most major manufacturers including Werner. Jershon Inc. recommends following installation instructions, which include cutting the bottom rung per UL guidelines to maintain the original ladder length and duty rating.

Level-EZE adds approximately 4–5 lbs to the ladder, compared to 8–11 lbs for typical manual levelers. The total leveler assembly weighs approximately 9.5 lbs, but the net addition to the ladder is minimal, helping to reduce back strain during transport and daily use by utility technicians and contractors.

Level-EZE is designed to outlast the life of the ladder and has been cycled over 90,000 times in testing with no failure. Maintenance is minimal: apply dry silicone spray (such as WD-40 Specialist Silicone or Teflon lube) occasionally, clean with pressurized water or air in dusty environments, and inspect the unit in icy or snowy conditions before use.